10 Packs Solderless LED Strip Connector Transparent Track Lighting Connectors Wire Strip Lights 16.4 ft Extension Cable Wire Cord for LED Light Speaker Electrical System(Retro Style, 4 Pin, 10 mm)

These work great for what they are. I wouldn't trust the connection to be sturdy, but that seems like an unlikely use case. I used these to install strip lighting on two shelves, and it was honestly a breeze.I had maybe a 25% failure rate on initial connection, but 100% of the time I was able to make them work after reseating the strip, and it ended up being user error every time. A simple set of pliers is all you need to get a nice positive connection.

Great connectors as well as matching wires. Made the jumps and long runs much easier than they otherwise would have been.

As you likely have found, Litcessory seems to have a monopoly on HUE Lightstrip Plus v4 connectors. I measured the HUE Lightstrip v4 with a digital caliper. 12mm wide. Great. This product should work... It does not. While the strip will fit the HUE Lightstrip, the pins will not connect properly. After forking over extra money for HUE, get ready to fork over more for these Litcessory connectors. There are limited options, unless you want to bust out the soldering iron. Even then, the connectors on v4 are CLOSE.

I used this wire and clips to route LED undercounter lights in our kitchen. The clips are a little hard to get the wire into, but that's more my old eyes that it is the fault of the clips.Everything worked perfectly the first time, no issues at all.

The clips were quite difficult to use and I could not get a connection to work no matter how hard I tried. The clip actually pierce the copper conductors so if you are unable to get it to work the first time, the LED strip is rendered unusable and has to be clipped to the next conductor point. It is hard to tell whether it was the LED Strip connection or the connection to the wire that was faulty. I would try finding clips that use compression which seem to work far better and are easier to use. I threw the entire package away.

I should write a one star review because that is all some people like me ever read, but these really work, and reading the one-star reviews I can only conclude that people who have issues are color blind and can't keep green to G and blue to B. I had 100% connectivity joining small strips of 10mm 5-conductor LED strip light, and all colors and white work perfectly on all joined segments. I've had good luck soldering in the past, too, but this was so much less effort. I just needed to ensure I had a very sharp knife to carefully cut off the thick waterproof covering. The only question I had was which side of the LED strip should be the one that gets pierced with the prongs in the connector. I pierced the top side. I had 100% success. Perhaps it makes no difference.

The wire work as well as it should lol. The clips on the other hand, work but a a little touchy. I had to bend the puns a bit to line up with my legs. The clips are also heavier than the LEDs could handle so I later had to super glue them to my cabnets.

I’m building a wall for my tv adding lights and this was smooth easy to install system.